请高手分析镜面光栅图
请高手分析镜面光栅图
大家新年好,近日抛光主镜出现下面的光栅图,麻烦高手分析以下镜面的面型,应该怎么纠正呢,254/1100,向内弯曲为焦点内。
- 附加檔案
-
- IMAG0369.jpg
- 焦点外
- (1.22 MiB) 已下載 4418 次
-
- IMAG0372.jpg
- 焦点内
- (1.44 MiB) 已下載 4418 次
-
- IMAG0371.jpg
- 焦点外
- (1.44 MiB) 已下載 4418 次
-
- IMAG0374.jpg
- 焦点内
- (1.3 MiB) 已下載 4418 次
美麗的星空 兄:
從以上光栅測試照片顯示反射鏡可能出現 "磨低邊" 現象。閣下可參考壇主黃Sir於2006年12月的 "光柵測試鏡面法" 貼文內容,希望能幫助閣下解決磨製反射鏡方面的疑難:
http://www.hkastroforum.net/viewtopic.php?t=8235
從以上光栅測試照片顯示反射鏡可能出現 "磨低邊" 現象。閣下可參考壇主黃Sir於2006年12月的 "光柵測試鏡面法" 貼文內容,希望能幫助閣下解決磨製反射鏡方面的疑難:
http://www.hkastroforum.net/viewtopic.php?t=8235
-
- 夸克星
- 文章: 3847
- 註冊時間: 週四 09 10月, 2003 21:06
Assume that the first picture is inside the center of curvature and the last is beyond.
Obviously you have a quite serious turned down edge. It is very difficult to cure by pitch lap alone.
The best solution is to go back to #1200 fine grinding for two hours ( or more ) and then polish the mirror again. The cause for turn down edge is too much force applied during polishing. Try not to press the mirror during polishing, it helps a lot.
Obviously you have a quite serious turned down edge. It is very difficult to cure by pitch lap alone.
The best solution is to go back to #1200 fine grinding for two hours ( or more ) and then polish the mirror again. The cause for turn down edge is too much force applied during polishing. Try not to press the mirror during polishing, it helps a lot.
-
- 夸克星
- 文章: 3847
- 註冊時間: 週四 09 10月, 2003 21:06
美麗的星空 兄:
修正磨低邊現象可參考壇主黃Sir於2012年7月16日的貼文內容,希望能幫助閣下解決磨鏡方面的疑難:
http://hkastroforum.net/viewtopic.php?p=248355
修正磨低邊現象可參考壇主黃Sir於2012年7月16日的貼文內容,希望能幫助閣下解決磨鏡方面的疑難:
http://hkastroforum.net/viewtopic.php?p=248355
誰在線上
正在瀏覽這個版面的使用者:沒有註冊會員 和 59 位訪客